Futaba 18SZA 18-Channel Computer Radio Control System
Futaba 18SZA 18-Channel Computer Radio Control System

Futaba 18SZA 18-Channel Computer Radio Control System

0 Review(s)
Availability: Out of Stock Free Shipping
Part Number: FUT_T18SZ
Futaba 18SZ Transmitter and Receiver
Write a Review

This is the Futaba 2.4GHz 18SZA 18-Channel Telemetry Airplane Radio System
with the R7008SB Telemetry Receiver.
Servos Not Included

This is the airplane version which will default to airplane settings
when powered up and has a ratcheted throttle stick.

10/17 Updates Include the Following;
Telemetry Display
Timer Alarm
Model Select (FX-32)
Data Converter
Butterfly Elevator
Butterfly Mixing
Butterfly Differential
Failsafe (FASST-7CH)

For all updates check http://www.futabarc.com/software-updates.html


Select between FASST, FASSTest, S-FHSS and T-FHSS (telemetry)
Telemetry sensors provide in-flight data on temperature, RPM
(magnetic & optic) altitude, voltage, GPS, current and data logging
**sensors not included, must be purchased separately**
4.3" full color LCD touch screen
Eight full transmitter conditions to customize every flight
Telemetry voice messages
Thirty model memory, expandable with memory card (not included)
Fifteen character model/user naming
Programmable mixing (10 circuits per condition)
User updateable software
Two side levers, six digital trims, eight toggle switches
Left and right sliders offer analog input
Data editor for S.Bus programming
Data converter
Failsafe (FASST-7CH)
Earphone jack
Thirteen airplane wing types, eight heli swash types, thirteen
glider wing types
Two up/down timers, system timer and model timer
6.6V 2100mAh LiFe transmitter battery
Servo monitor
Dual receiver setup
Logic switch
One year limited warranty through the Futaba USA Service Center
beginning at date of purchase

Airplane Features;
13 Wing Types 2 Rudder Types
3 Tail Types Flap Setting
Aileron Differential Aileron to Camber Flap Mix
Aileron to Brake Flap Mix Aileron to Rudder Mix
Aileron to Elevator Mix Rudder to Aileron Mix
Rudder to Elevator Mix Camber Mix
Elevator to Camber Mix Camber Flap to Elevator Mix
Snap Roll Airbrake Mix
V-Tail Ailevator
Winglet Motor Mix
Multi-Engine Gyro Sensor

Helicopter Features;
8 Swash Types Pitch Throttle Curve
Pitch Throttle Curve Pitch Throttle Curve Mode (3)
Acceleration 17 Point Pitch/Throttle Curve
Throttle Hold Swash Mixing
Throttle Mixing Pitch to Needle Mixing
Pitch to Rudder Mixing Gyro Sensor (3)
Governor Condition Hold
Hovering Pitch Hovering Throttle
Swash AFR Swash Setting
Swash Ring Throttle Limiter

Glider Features;
13 wing types Aileron Differential
3 Tail Types Aileron to Camber Flap Mix
2 Rudder Types Aileron to Brake Flap Mix
Flap Setting Camber Mix
Aileron to Rudder Mix Elevator to Camber Mix
Rudder to Aileron Mix Camber Flap to Elevator Mix
Airbrake to Elevator Mix Butterfly Mixing
Trim Mix 1 Butterfly to Elevator
Trim Mix 2 Butterfly Differential
Ailevator V-Tail
Motor Mix Winglet

Multicopter Feature;


18SZA 18-Channel Aircraft Transmitter
R7008SB Telemetry Receiver, FUTL7675
FT2F2100BV2 6.6V 2100mAh LiFe Transmitter Battery
Battery Charger
Switch Harness
Instruction Manual
Small Screwdriver


Servos of modeler's choice (analog servos cannot be used if
FASSTest 12CH mode is used)


Transmitting Frequency: 2.4GHz band
S-FHSS switchable
Power Supply: 6.6V FT2F2100BV2 LiFe battery

Receiving Frequency: 2.4GHz FASSTest system
Power Requirement: 3.7 - 7.4V (voltage range 3.5 - 8.4V)
Current drain: 75mA
External voltage Port: 0 - 70V DC
Size: 0.98 x 1.9 x 0.56" (24.9 x 47.3 x 14.3mm)
Weight: 0.38oz (10.9g)
Antenna Length: 5-3/4" (146mm)