MKS Servo with Full Aluminum Case and Titanium Gears
The
MKS HV High Voltage Servo series is designed to operate at high voltage
and low current, delivering higher torque per unit weight. A control
data rate of 333Hz makes the MKS HV servo an exceptionally agile,
ultra-fast responding product with precise control. Titanium gears, dual
ball bearing output shaft, and strong overload protection delivers low
noise, durability and long life.
- Dead Band: 0.0008 ms (Default)
- Control System: +Pulse Width Control
- Working Frequency: 1520µs / 333hz
- (RX) Required Pulse: 3.5 ~8.4 Volt Peak to Peak Square Wave
- Operating Voltage: 6.0 ~7.4 V DC Volts
- Operating Temperature Range: -10 to + 60 Degree C
- Operating Speed (6V): 0.14 sec/60° degrees at no load
- Operating Speed (7.4V): 0.11 sec/60° degrees at no load
- Operating Speed (8.4V): 0.10 sec/60° degrees at no load
- Stall Torque (6V): 388 oz/in (28.00 kg/cm)
- Stall Torque (7.4V): 506 oz/in (36.5 kg/cm)
- Stall Torque (8.4V): 527 oz/in (38.00 kg/cm)
- Torque: 520 oz/[email protected]
- 360° Modifiable: NO
- Motor Type: Coreless Motor
- Potentiometer Drive: Indirect Drive
- Driver Type: FET
- Bearing Type: Dual Ball Bearings
- Gear Type: Titanium Gears
- Programmable: NO
- Connector Wire Length: 15.0 cm (5.9 in)
- Dimensions: 40X20X45 mm (1.57x0.97x1.77 in)
- Weight: 81.4 g